MAGIC AIR

Hold the can upright. Do not shake. Do not tilt more than 30°. If tilted further, the can will spray an extremely cold product, which can dangerously freeze the skin. 

Hold the can upside down

Spray generously on the surface to be worked. Let the cold penetrate for a minute, then spray again thoroughly. Let the cold work for another ten seconds, after which (dis)assembly can be performed.

Tip: It is best to warm up the entire assembly, including the part to be disassembled, before freezing! When disassembling, shield the part that should not freeze by using a plate or hollow wrench.

Hold the can upright:

Safely removes dust, dries, and cleans circuit boards, office machines, fine mechanics, sensitive surfaces, plastics, paints, computer keyboards, and more. Leaves no film or residue. Convenient for use in places where no compressor is available.

Hold the can upside down: An important tool for assembly and disassembly by means of a large cold shrink of nipples, glow plugs, pipes, pins, etc. Ideal for testing circuit boards, temperature controllers, resistance controllers, bimetals, temperature sensors through cooling control. Cooling various materials. Important: First turn off the power, freeze, let it evaporate, and then turn the power back on. 

Wear appropriate clothing. Do not shake the can before use. Protect from sunlight and do not expose to temperatures higher than 50°C. Even after use, do not puncture or burn. Keep out of reach of children. Always allow the flammable gases to evaporate before turning the power on.